Mapping help please - Yamaha Raptor Forum
 1Likes
  • 1 Post By TorchTarga94
 
LinkBack Thread Tools Display Modes
post #1 of 6 (permalink) Old 06-18-2019, 03:38 PM Thread Starter
Junior Member
 
Join Date: Apr 2019
Posts: 8
Mapping help please

I have a 19' raptor, with stock exhaust , a k and n air filter and a moflo air box lid,

I purchased a Dyno jet 5 fuel and ignition control, but cannot find a map for my set up

I plan to purchase an exhaust system at some point, but, will runtime current set up for awhile.

Do I need to change the mapping at this point?

thank you for your help!
rrrraptorrr is offline  
Sponsored Links
Advertisement
 
post #2 of 6 (permalink) Old 06-18-2019, 08:18 PM
POTW Moderator

 
Join Date: May 2012
Location: Northern Colorado
Posts: 7,498
Garage
Have you looked through dyno jets website to find something close? Doesn't need to be exact...

[U]2006 raptor 700

DMC Force 4's, FCI W/box, Dynatek Fusion
CP 11:1 piston, BaMotorsports porting, HC3
RacersEdge +3TB
YFZ 450 fronts & reworked rear by JOGACA
Trailtech 1 1/8 xbar w/vapor dash & Vapor installed
ODI Rogue grips & ASV pro pack levers
PRM Edge Baja bumper w/12" Cree spot/flood bar
PRM Desert grab bar
PRM A-Arm skids, GYTR skid, ProArmor swinger skid
Fastway steering stabilizer
68HP 49TQ

PM me if you need service manuals
morphrider is offline  
post #3 of 6 (permalink) Old 06-19-2019, 06:06 AM Thread Starter
Junior Member
 
Join Date: Apr 2019
Posts: 8
yes,
unless i missed something, there was not a tune offered for a stock exhaust with a modified air box
rrrraptorrr is offline  
 
post #4 of 6 (permalink) Old 06-19-2019, 06:41 AM
Senior Member
 
TorchTarga94's Avatar
 
Join Date: Dec 2017
Location: Trinity, FL
Posts: 286
Quote:
Originally Posted by rrrraptorrr View Post
yes,
unless i missed something, there was not a tune offered for a stock exhaust with a modified air box
Use Map 22-074-002 (Stock exhaust system GYTR Intake kit Airbox lid removed). That will get you pretty close if not a little on the rich side which isn't a bad thing.
morphrider likes this.

06' 700 SE
-Pro Taper/ Odi/ ASV-
-Jogaca-
-GT Thunder-
-Alba-
-Lonestar-
-Streamline-
-Precision-
-IMS/Roll-
-PC5-
-HMF-
TorchTarga94 is offline  
post #5 of 6 (permalink) Old 06-25-2019, 09:26 AM
Junior Member
 
Join Date: Jun 2019
Posts: 1
I just installed my Power Commander 5 yesterday and noticed same issue. he maps available are quite limited. I thin that I would put the airbox lid on and run the filter you have until you put the exhaust on, then there are maps to accommodate your set up. I am running the stock PCV setup right now since I haven't installed my exhaust, intake with EHS outwears lid and GYTR intake. I know that the outwears/moflo airbox lid makes a big difference many years ago as I have a new Honda 400ex and put the lid on with jetting and it ran horrible so I had to remove it until I changed the jetting. However, in this case the fuel injection might be able to accommodate it, but I am not sure. I would be inclined to wait until you have a map that is a little closer to the setup before removing the lid. Tough call on this one as it might be fine since PCV richens up mapping from stock.
jandrew is offline  
post #6 of 6 (permalink) Old 06-27-2019, 04:17 AM
Junior Member
 
Join Date: Jun 2019
Location: Leicester, UK
Posts: 4
I was running lean with an FMF exhaust set up using the map they had on the site, I gave them a call yesterday and they've sent me a new FMF map.

Update dynojet sent me the same map that's on their site. Hopeless!!

Last edited by Spencer; 06-27-2019 at 03:07 PM. Reason: Tested the new map it's garbage
Spencer is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Yamaha Raptor Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome