I may be getting older, but I refuse to grow up!
Join Date: Jun 2012
Location: PACIFIC N.W.
Iíve got an 05 350 Raptor. The carrier bearings went out and ruined the axle and the housing the bearing sit in. So I bought aftermarket parts off of eBay mainly because itís a 05. All this being said. I cannot get the rear brake caliper to mount in the proper location. Itís seems to be 2Ē where it should be. where it well grab the rotor. Am I missing something or should I look into alternative mounts?
I'm not a expert on 350's, but is the sprocket hub (other side) seated in the seal and on the axle proper? There may be a round snap ring seated in a grove in the axle to hold it. Or, could the rotor be mounted on the wrong side of the hub, or the hub backwards?
'19 Can-Am X3, RS Turbo, 172 HP, 1300x15 STU #2 paddle, Tribute front, DynaTec controller, cat delete, GTP blow off valve, custom flame wrap, Bent Metal windshield, Blazer wiper, rear window, 48in LED light bar, 14in LED light bar, GTP LED side lights, S3 shock tower brace, aluminum rear pull plate, 5K Badlands winch, dual batteries, 5ft lighted whips, Rugged radio and intercom, interior lights, rock lights, chase lights, over $200 additional switches, YES, street legal with dirt tires.