Raptor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Raptor 350 Discussion
    Just picked this up last week with a no start condition. Guy said he took to a shop and they tested everything and claimed it was the CDI. I bought a test dummy off Amazon before going all in on a 150 and up unit. It worked for a day. Next day no speak again. Only thing I did was left the gas on...
  2. New Member Introductions
    Just pick this up less than a week ago. Got it with a no spark issues diag by a shop to be the cdi. Replaced it and csi dies again hoping someone can guide me to fix this issue.
  3. Raptor 350 Discussion
    Me again, my buddy and I replaced the head gasket due to the old one blowing by (ran fine without it), replaced it last night and was doing the finishing touches (gas tank plastics etc) and went to go start it and it would crank, but not start. So we checked for all the main causes, fuel air and...
  4. Raptor 350 Discussion
    Hey everyone, I just finished painting my raptor and want to put some graphics on it, (either stock or cool ones) and was wondering if you guys had any websites where I could get either for fairly cheap. I'm a college student on a budget and anything helps! thank you
  5. Raptor 350 Discussion
    Im having an issue where I have power going into my starter relay but doesn't go to the starter. I have tried a test light on it and the two wires from the starter switch on the handlebars both trip the light when i press the button but doesn't activate the starter most of the time. What i mean...
  6. Raptor 350 Discussion
    Hi I have a 08 350 that the starter is sticking up when I turn it over and when a turn it off just as the motor stops. It is still rideable but would like to fix this issue before I go to the mountains in June. Would I need a whole new starter or is there a way it can be oiled. Thanks.
  7. Raptor 350 Discussion
    So my 350 started blowing back through the carb one morning so I pulled the head and seen that the intake valve isn’t closing all the way. It isn’t bent or stuck in place. When you turn the cam over the rocker opens the valve like it’s supposed to, then when it’s closing it just barely gets...
1-7 of 7 Results
Top