Search Results for ‘help’

I have a certain project in mind and it would be extremely helpful if you guys can give me some information regarding the stock 2015+ raptor 700 pistons 1- what is the compression height 2- what is the piston pin outer/inner diameter 3- what is the piston weight(including pin locks and rings)...

i bought a 02 raptor 660 a few months ago and its missing a ton of electrical parts and i was able to hot wire it and get it to start and it idle really good for a few minutes then right as im abut to ride it bang bang bang shuts off then i restarted it and its knocking super lound like wont...

It won't start so we bumped it and it has alot of lag on the bottom end and it's just not running right its back firing and it doesn't want to Rev up I took the air box lid off and it helped it alot I just want help finding out what's wrong I've messed with the jets and when I went to tune it it...

I just bought a new set of sprockets and chain, I replaced them and when adjusting the chain I noticed that when my friend sat on the quad the chain would loosen instead of tightening like all other quads I've owned. The chain was about at 1 inch of travel uncompressed and when my friend sat on...

Hello Raptor Forum, I just made a very impulsive purchase and picked up an 05 raptor 660 having never owned or worked on a quad before. Good ole Facebook marketplace came thru with a pretty solid bike with a few small issues. Right now I’m trying to figure out a solution to a small oil leak at...

hey my fellow raptor lovers. i’ve got a mint 07 raptor, she’s always taken care of. oil changed every 2 tanks, everything stays lubricated and greased. stored in a heated garage. i was riding one day in second gear, pretty low revs, nothing serious at all. all of the sudden, the quad starts to...

I just bought an 03 raptor 660 from a guy on marketplace. Its a basket case, as in the parts were all in a basket lol. Slowly been putting the motor back. Not my first motor, have built tons and tons of two strokes, kinda new to the four stroke scene. The motor went back together perfectly until...

Hello guys am new there, I just buy a raptor 660r 2004 (my first “real” quad) and when am at high speed there are a spring noise .. something like that from the front engine . idk it that normal, can someone help me pls. In the video you can hear, it just need to raise the sound a bit video...

Hi guys! New to the forum here. i need a bit of advice from those that have a bit more time on quads and atvs than i do. my girlfriend and i are in the market for four wheelers. i live in New Hampshire and will do lots of north east trails, woods, and park riding. where i live, the elevation...

Okay so here's the deal last Sunday I bought a 2001 Yamaha Raptor. Took her for a short test drive and it drove fine very little smoke if any. Gotten home and started to look it down to repair a few things on it. Well I started it up and i noticed a bit more smoke then before. Well I thought it...

I was trying to remove the oil drain bolt to do an oil change and it of course snapped because that's just my luck. Here's what it looks like right now, looking for any suggestions on how to remove it. I tried locking pliers and using a flathead at an angle then hitting it with a hammer to try...

I have an 03 660 and I was doing some transmission work. It went well but when I was putting my clutch cover back on a small cylinder fell out and I have no clue where it is meant to be. I don’t remember it when I disassembled everything and can’t find any mention of it in the manual’s clutch...

I just recently bought a 2005 Raptor 350. The guy said the rear brakes need new pads and I was fine with that, it would be easy to install new pads. However, after I was done, I tried pumping the brakes and everything. The brake lever will go down all the way with no pressure, and I get no...

2018 Raptor 700R, 2nd day into my 5 day trip with a bike that won’t run! HELP !! Last weekend I did a completed oil change and cleaned the air box since it sat all winter. Thursday of this week the bike got to the facility we traveled to ride. The bike started and ran great all day. Today...

Hello I need help ! My 2002 Yamaha Raptor 660 will not turn over when the valve cover is on and when I do try the nut comes loose, but when the valve cover is off I can turn it over like butter , and yes the plugs out!

Hi, new here but i just bought a 2020 raptor 700 and not sure if i wanna get an exhaust yet, mainly money issues but will removing my spark arrestor void the warranty? I feel like it shouldn't but wanted to see if anyone really knew.

Hey guys in need of some help. I have a 2005 raptor 660 that I just baught for $700 and i was told last time it ran that it started backfiring and stalled out like it was running out of gas. Then he didn’t mess with it since. I got it home and ordered a new carb because the old one look trashed...

What’s happening guy New to this whole quad thing so if I say anything wrong I apologise in advance.. right so I have a raptor 660r bought of a mate (well used) says it’s 2006 on the reg search but it’s obviously got to be 2005 or after (maybe registered as road legal in 2006) mods that I...

It just won't come out!!!! I've removed everything from the top and bottom but it doesn't just slide out like everyone keeps saying. Do I just add some heat and hammer on it? Please help. This is my first rebuild

Hey guys I have a 06 raptor 700R and I’ve ran into a problem. I recently rebuilt the top end on it, put it all back together, got a new battery and tried to fire it up, at first it was trying but the starter relay started to buzz and also the EFI resets every time I hit the electric start? So I...