Raptor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Raptor 660 Modifications
    Hey guys, screwed up big time. Broke the back of the valve cover when taking it off. I feel pretty stupid apparently I missed the two under the cap. And I was going by the book. Is this repairable with a good TIG welder? Any thoughts ? I REALLY don’t want to buy a whole new setup.
  2. General 660 Discussion
    So the head cover didn’t have a gasket and the cylinder head had 2 gaskets stacked. I accidentally busted the head cover.😞 Can I just replace the cover or do I have to do a whole new valve case and cover?
  3. Raptor 660 Maintenance
    Hey guys put a new drain plug in so I drained all the oil since I ran it last. Oil was whitish what do I need to do to fix this issue? Ua
  4. Raptor 660 Maintenance
    Any idea of the size of rivets? How do I measure them? Width of the head?
  5. Raptor 660 Maintenance
    I want to clean and polish every inch of Aluminum on my Raptor. Some areas are worse thank others. As far as I can tell it’s the oil reservoir, exhaust muffler, exhaust guards, clutch and brake levers, wheels, license plate bracket, carb, cylinder, head, back grab bar, front bumper, probably...
  6. Raptor 660 Modifications
    Hey guys, I am planning on replacing the rear and back sprockets with a new chain. Can someone explain to me what does the different amount of tooth’s do? Not sure what to pick. My plan it to highly modify my raptor as time goes on.
  7. Raptor 660 Modifications
    Anyone run this? Thoughts?
  8. Raptor 660 Modifications
    Anyone ran this chain? Wanting to replace old chain and sprockets. Is there a quality product list of manufacturers for aftermarket parts? Like by part and manufacture. Thank you for the help. I want to make sure I’m putting quality products on.
1-8 of 8 Results