Search Results for ‘raptor 660 problem’

We just put a new carb in and have been tuning it but every time we test drive it the needle jets keeps popping out of the diaphragm (the small spring and plastic holder). We have tried switching out the old diaphragm and jets but it keeps popping out and then it just sputters or won't start...

i am tryng to figure out how t ohook up the battery on this raptor 660 i just bought, there is multiple wires the go to under the seat there is one that i belive is the ground it comes from the right side of the starter if your sitting on it and is bolted on to thew starter there is also a thin...

Hey so I was riding and I shut my 2002 raptor 660r off and when I went to go start it back up and it just spun so I figured the starter or the starter clutch went out so I bumped started it and rode for the rest of the weekend,when I got back home and took it apart the starter clutch was broke...

It won't start so we bumped it and it has alot of lag on the bottom end and it's just not running right its back firing and it doesn't want to Rev up I took the air box lid off and it helped it alot I just want help finding out what's wrong I've messed with the jets and when I went to tune it it...

I bought a 2005 raptor 660 and have been chasing problem after problem. It has a no lid air box with a slip on. Sadly I bought it with a Chinese carb on it. It idles really well but can’t give it ANY throttle without it bogging and backfiring. I have stock jets in it with the needle position at...

So I’ll just start off, replaced clutch with a dp clutch, put it all back together and it ran fine for about a week. Was going back and forth to work. But the previous owner was using synthetic oil prior to me rebuilding clutch, I ended up just throwing in valvoline motorcycle oil 10w40 (don’t...

I have to start with this because I suspect this may be part of the problem, unfortunately it has an eBay carb:( the carb is clean though and I’ve messed with the air fuel ratio screws and cleaned up the problem a little bit. The problem is when I get on the gas hard it stumbles at the low rpms...