Raptor Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
386 Posts
Discussion Starter #1
i ordered and installed a +2 armadillo Aarm kit from rocky mountain the problem is that every thing went together well but when i go lock to lock left to right the rims rub on the bottom arm on the inside i dont understand.
the kit came withe +2 tie rods and were to the best of my knowledge put on correctly the caster and camber look good everything looks ok except the rims hit the aarms before it hits the stoppers on the steering stem.
any help or ideas would be appretiated.
 

·
Registered
Joined
·
386 Posts
Discussion Starter #2
i used the original balljoints from rappy, maby tighter newones will help
 

·
Registered
Joined
·
386 Posts
Discussion Starter #3
i dont know if it matters or not but the balljoint lock nut i put on the inside of the aarm, should it be on the outside/hub side of the aarm?
 

·
I am unique
Joined
·
22,621 Posts
i dont know if it matters or not but the balljoint lock nut i put on the inside of the aarm, should it be on the outside/hub side of the aarm?
I doubt if that will make any difference................
Are you using the stock rims, you may need rims with more offset.............
 
1 - 4 of 4 Posts
Top