I would place bets on the swingarm bearings and bushes been shot rather than the frame twisted
2004 660r Carb issue and frame/alignment.
Attached some pictures of the quad where i believe the frame is slightly bent/crooked.
as far as the carb. Took it out this weekend ran fine. Did notice that once started the second carb would occasionally dump gas for about 20 seconds then stop. Ran fine for 2-3 hours. Hit creek then slowly started to big down. Seemed flooded a bit after that.
Carb started dumping more. Would start up, pur then bog down.
Debating on doing a frame swap but would like to avoid that as much as possible. Would like to get alignment better any ideas where to start?
As far as the carb issue goes, what would you recommend. Clean and replace jets or get brand new carburetor?
![Plant Sky Nature Tree Motor vehicle]()
![Wheel Sky Cloud Plant Self-propelled artillery]()
![Tire Bicycle tire Crankset Bicycle frame Motor vehicle]()
![Tire Wheel Automotive tire Motor vehicle Tread]()
as far as the carb. Took it out this weekend ran fine. Did notice that once started the second carb would occasionally dump gas for about 20 seconds then stop. Ran fine for 2-3 hours. Hit creek then slowly started to big down. Seemed flooded a bit after that.
Carb started dumping more. Would start up, pur then bog down.
Debating on doing a frame swap but would like to avoid that as much as possible. Would like to get alignment better any ideas where to start?
As far as the carb issue goes, what would you recommend. Clean and replace jets or get brand new carburetor?
