[DoctaRaptor01]

I have an 03 raptor 660 when i bought the wheeler there was a random wire hooked to the negative side of the battery and the guy i bought it from said it was an override for the parking brake and clutch sensor and said the bike had no power and wouldnt rev up if this was disconnected so i left it alone because the bike ran great. A few days ago i changed the wiring harness because of some other issues, after putting the wheeler all back together today i go to take it for a ride and when i go to take off as soon as i give it any throttle in gear it just cuts out completely . I was wondering if anyone could tell me were to override it from or wut to do to override it? Thanx alot!!

 

[Tommy Warren]

welcome....congrats on the raptor....just remember to check the stickies before you post a problem....they are at the top of the general 660 discussion forum. here is whats wrong...check out number 2 on this list

http://www.raptorforum.com/forums/showthread.php?t=60922

 

[DoctaRaptor01]

i read number 2 but still dont understand exactly wut i need to do to override it

 

[QuadManiac]

I'll bet the green/white wire is not plugged into the reverse switch (below the output sprocket) which would make it and the reverse light work properly, OR it is not grounded - which was that extra wire you described. Just put it where it belongs OR ground it... that's it.