Raptor Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
204 Posts
Discussion Starter #1
I am selling my drag bike. I have everything except the engine, which was already sold. This is a highly modified stock frame bike, and is one of the lightest stock frame raptors. With engine (including electric starter and stock battery) full of fluids ready to run weighed in a hair over 300 lbs. Here are the parts left to sell (pretty much everything you see in the pictures). Also all these parts frame etc… have 2 rides on them. I sold the motor out of this bike and now decided to just sell the rest since I hardly have any time to ride it anymore. The powder coating and frame mods were done this winter. The plastics actually just got painted, and have only been set on the frame for these pictures.

I would like to sell the complete roller, so make an offer. If not I’ll part it out.

Here’s what’s included in this roller:

Modified stock frame, with aluminum sub frame.

Stock raptor plastic drag cut. It was then sanded down and painted with a base coat and clear coated. Then air brushed and clear coated again.

Ultimate light weight drag a-arms configured +1” forward and -1.5” narrower. With billet tie rods

Stock aluminum spindles which have been modified, lighted, and powder coated.

10x4 spindle mount rims with 18” smooth buff tires.

Stock radiator

Light weight chromoly one piece steering stem/handle bars.

Terry Cable thumb throttle

Quick adjust clutch perch

Stock fuel tank with chrome pingle high flow fuel valve, with reserve

Brand new +6” light weight chrome swingarm setup with new pivot tube bearings and no link shock and maltese cross housing.

+8” chrome swingarm with no link shock, chrome, maltese cross (both swingarms look the same, except one is 2 inches longer)

Powder coated rear brake caliper.

Polished brake master cylinder

SS rear brake line

JJ and A 40mm bearing carrier Powder coated red to match frame with brake plate kit

28.5” jj and a aluminum axle which has been polished and has 4 spoke raptor 700 sprocket hub

Light weight wave brake rotor

Aluminum sprockets for raptor 700 bolt pattern

Ti-moly Sidewinder chain long enough for +8” swingarm I think it is around 130 links

Front marvin shaw hill shooter shocks 14” long

Rear hill shooter shock setup for direct link swingarm 15” long

Polished aluminum grab bar

All SS polished frame bolts

Polished oil tank and polished oil lines (not shown in picture)

Stock raptor seat

Also have ultra light weight paddles mounted on wheels

Everything is in perfect show bike shape, as I am super picky. Most of the frame mods were done this winter for this summers riding season, but I didn’t ride it much.

I'll try to get some pics up soon, but for now you can go to this link: http://geisickperformance.com/raptor_pictures.htm and scroll down to the bottom. The last three pictures are what it looks like now. (the other pics are how it looked before) This is a huge web page, so if you have slow internet forget about looking at the pics, sorry

If you have any questions please pm me or give me a call 970-768-7168 and leave a message
 
1 - 4 of 4 Posts
Top