Raptor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
988 Posts
Discussion Starter · #1 ·
I got the 700 alittle hot yesterday and she puked a decent bit of coolant out so im just gonna go ahead and flush it out today, i know about the Airbleed bolt/screw (i have to look up the location though) but is it pretty similar to the 660 Raptors then flushing wise?....thanks :thumbsup:
 
G

·
All you have to do is drain the coolant from the coolant reservoir by disconnecting the hose, then remove the radiator cap and then remove the coolant drain bolt and the rest of the coolant will drain. The air bleed bolt is located on the back of your thermostat, it's the middle bolt.
 

·
Registered
Joined
·
988 Posts
Discussion Starter · #3 ·
is the air bleed bolt accessible w/o removing the front plastic and just the hood?
 
G

·
yeah, if your sitting on the quad, it's on the motor on the right hand side, you don't have to remove anything to see it.
 
1 - 4 of 4 Posts
Top