Raptor Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
455 Posts
Discussion Starter · #1 ·
where can i find control arm ball joints? (not tie rod ball joints)
 

·
Registered
Joined
·
210 Posts
I got mine from the local Yammi dealer. About $25 a piece if I remember correctly.
 

·
Registered
Joined
·
455 Posts
Discussion Starter · #3 ·
can i re-grease my ball joints?
 

·
Registered
Joined
·
210 Posts
ajax660 said:
can i re-grease my ball joints?

They are non-greasable from the factory.
 

·
Registered
Joined
·
455 Posts
Discussion Starter · #5 ·
do you think i can powercoat my A-arms with them in or will the grease get all f*cked up cause its not high temp grease or will it be fine?
 

·
Registered
Joined
·
210 Posts
ajax660 said:
do you think i can powercoat my A-arms with them in or will the grease get all f*cked up cause its not high temp grease or will it be fine?
I don't think you can do it. But your powdercoater would be the best person to ask.
 

·
Registered
Joined
·
455 Posts
Discussion Starter · #7 ·
thanks for the info man i really appreciate it :thumbsup:
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top