Raptor Forum banner

1 - 1 of 1 Posts

1 Posts
Discussion Starter #1
Hi every1
I'm trying 2 source some lower ball joints 4 my daughters buggy.
The block i bought it off says the extended A arms are off a 660 raptor.
Now this is were i could do with some help.
As any1 got the measurement of the lower ball joint, or as 1 they could measure 4 me.
The measurement i need are width an depth (where it is seated in the A arm) an castle nut size.
Thank you for reading an hopefully 1 of you can help.
Thanks Bugg
1 - 1 of 1 Posts