Raptor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I recently bought an 04 Raptor today and go figure it needed axle bearings desperately so I tore down the rear end to find the bearing shredded and the carrier egg shaped. Can anyone give advice as to what carrier to replace it with? It's an aftermarket billet one better than a stock one for a stock application? I would love to find a stock one for relatively cheap to get the quad back on all four. Can anyone help?
 

·
Registered
Joined
·
6,002 Posts
A billet one is not much better then a stock one aside from the cool factor. The price on a billet one is not bad though. They run about $135 shipped. Most stock ones seem to run about $100 used. I have a stock 660 carrier I would sell. I would sell it for $75 shipped to you. Bearings and seals were all good I just parted out the quad to buy my 700:metal:
 

·
Registered
Joined
·
6,002 Posts
Payment received will be shipping it tomorrow to you. Both Sprocket hub and carrier with the bolts and bracket will be in one box. Thanks
 
1 - 4 of 4 Posts
Top