Raptor Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
689 Posts
Discussion Starter #1
If I think I have a bent flywheel what I'm I looking for. As far as riding and the feel of the motor. Also If I'm going to get a new fly wheel is there any one out there doing work to them (as far as weight).
 

·
Registered
Joined
·
3,586 Posts
I dont know how one would even bend a flywheel. But, if you did perhaps the magnets are broke?....that would be one way of telling. The quad should idle and run like ass too. Should pulsate
 

·
Registered
Joined
·
689 Posts
Discussion Starter #3
Not useing right tools to remove the flywheel would have me thinking this. Bike idles fine runs great. Just can't figure way my bike does not pull as hard when going into 4 and 5 gear as it does in 1,2,3. Was thinking maybe the flywheel. Maybe just need more work on my fi controller.
 

·
Registered
Joined
·
3,586 Posts
what do you mean??? No bike is going to pull as hard in the upper gears, like it does in the lower ones! Less torque once you get into the upper gears with low ratio's.
Definately want to use a flywheel puller ;)
 

·
Registered
Joined
·
689 Posts
Discussion Starter #5
Thanks boom, know where I can get one for the 700.
 

·
Registered
Joined
·
3,586 Posts
nope....sorry, I havnt run across one yet. I have one for the yfz....but I doubt they are the same?
 

·
Registered
Joined
·
689 Posts
Discussion Starter #8
Come on sparky where can I get one. Or which is the same for the 700.
 
1 - 8 of 8 Posts
Top