Raptor Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter #1
i received my hot cams stage 3 and the instructions say to keep the motor reved at 3000rpm for 30 minutes. and then check the valve clearance again. what does everyone else do for breaking in?
 

·
8SEVENTY3
Joined
·
1,336 Posts
Install it and set the valves in the right spot...go cruise around for a day or so and check the clearances again. You can check them after a couple weeks just to make sure as well.
 
1 - 5 of 5 Posts
Top