Raptor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
I have a 350 Warrior, & Last week, My wiring harness got caught in my chain, Needless to say it chewed the piss out of it. The CDI box was also got by the chain. I ordered a wiring harness & CDI, Got it all on, Cranked right up, Idles good Takes fuel, But Pops & Cracks through the exhaust. Any thoughts?
Thanks for any help,
Bill
 

·
I am unique
Joined
·
22,621 Posts
I have a 350 Warrior, & Last week, My wiring harness got caught in my chain, Needless to say it chewed the piss out of it. The CDI box was also got by the chain. I ordered a wiring harness & CDI, Got it all on, Cranked right up, Idles good Takes fuel, But Pops & Cracks through the exhaust. Any thoughts?
Thanks for any help,
Bill
I believe they have a reverse rev limiter that may be causing your problem. I'm going by memory here. Check for a ground wire at the reverse lever area................
 

·
Registered
Joined
·
7,128 Posts
I unplugged my reverse sensor:).... I also relocated my wires so they wouldnt get caught, I just re-routed them ontop of the plastics instead of "through". It makes it 10 times easier to remove the fenders also.......
 
1 - 4 of 4 Posts
Top