Raptor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,674 Posts
Discussion Starter · #1 ·
I finally got my jets today, so I've been installing them.

Anyways, I've now got 150/155 with 25 pilots. I hope it works well with my stock quad with just the Freez mods and no lid/K&N.

Anyways, my clips are supposed to be in the 3rd position for this setup.... So is that third from the bottom? Like right now my little c-rings are clipped on the second groove from the top.

Top as in the clip end, bottom as in the part that goes down into the carb.
 

·
Super Moderator
Joined
·
17,061 Posts
Well this should make it easier, there are 5 clip positions on the oem and gytr needles so 3rd clip is the middle. ;)

As you move the clip farther up the needle it leans out the mixture because more needle is in the carb and restricts flow. As you move the clip farther down the needle less is inside the fuel flow and so richens the mixture.

I've always referred to it as the richest position being the 5th clip and leanest being the 1st, but I've heard it both ways.
 

·
Registered
Joined
·
1,674 Posts
Discussion Starter · #3 ·
Ok, then I think it's on the 2nd clip right now then. It was jetted for high altitude. 135/140 with the clip on #2.
 
1 - 3 of 3 Posts
Top