Raptor Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Here's my deal 2003 660 New Tusk clutch, fibers and steels. Everything is adjusted correct but my cluch doesnt start to disengage till my lever is 3/4 the way out then fully disengaged just before the end of the handle travel. Tried everything I could think of. I would like it to be disengaging as soon as I start to release the handle. Could this be a basket and pressure plate wear issue?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top