Raptor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I've been looking at skid plates online they are pretty expensive for a piece of welded aluminum. By looking at them I should be able to fab them up with out a problem in my shop. I already have a sheet of 6061 .25 inch hardened aluminum. Has anyone else ever done this? If so how did it turn out? Any Pics? Thanks kt
 

·
Registered
Joined
·
1,488 Posts
If you check ebay they go for pretty cheap. I know the GYTR skids are very expensive. But if you make your own dont forget to make a hole to acess the oil drain.
 

·
Registered
Joined
·
238 Posts
If you have a bender I'm sure it could easily be done. I'd do a cardboard mock up to get the measurements where ya want them and go for the real deal!! Post up some pics of your creation when ya get done!
 
1 - 4 of 4 Posts
Top