Raptor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
319 Posts
Discussion Starter · #1 ·
i have purchased a dyna tek FS ignition and have a pro armour tether/kill swich on the quad, this is quoted from the installation manual


"Installation of a grounded tether kill switch to the ignition coil signal
will damage the CDI and void the warranty.
12V Inductive Ignition (Raptor 700R/etc.): 
To use a normally closed tether kill switch connected in series with the +12V input (RED/BLACK) to the
ignition. When the tether is removed, it should disconnect the +12V power to the ignition."

can someone please translate in simply terms as i think im being really stupid as i dont understand:confused: and i dont want to break it ::)
 

·
Registered
Joined
·
191 Posts
Wire it to the ignition key barrel.Red/black wire
 

·
Registered
Joined
·
881 Posts
I have a 660 and there was a tether already installed when i bought it. I changed out the the stock cdi for a dynatek. Will i mess it up if the tether does comes undone and kills the quad?
 
1 - 4 of 4 Posts
Top