Raptor Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
320 Posts
Discussion Starter #1
I have a tag one my grab bar. It`s a cut down airbrushed car tag and it covers my brake light.

I have 2 skull heads that have a led in each eyeball blue color 2 lights per mount.

I would like to know how I could tap into the brake light wires and which wire... so i can use the lights as brake lights. I could buy 2 more skulls either blue are red and would like to have the option to wire them to always be on when lights are on are have them to only come on when i hit the brake are even have 2 blues to always stay on with lights and 2 reds to only come on when i hit brake. Hope i make sense.
 

·
Registered
Joined
·
827 Posts
if you do not know colors and do not have the clymer manual you may need to go down to your local radio shack and invest in a cheap digital multi meter. you can then figure out which wire recieves +12v when the brake is pushed. you can also use a test light. you dont neccessarily need to find the ground wire as the entire chasis of the quad is a ground. have fun and post pics when finished.
 
1 - 2 of 2 Posts
Top