[Guest]

i put a set of pro taper lo pro bars with the cross over bar on my raptor and the rub the tank. what kind of bars can i get that are low like that but wont hit? i dont realy like high bars

 

[Bush_Pilot]

i think the raptor bend bars are the only ones that dont rub. i have pro taper se atv hi bend and i love them. so it may rub a little at full lock but who cares.

 

[Glamis700]

I have the same bars that Bush does.

The height of the bend is not why the bars rub, its the width where the steering stem clamps to.

Are you a short person? Just wondering why you like low bend bars.

 

[Guest]

no i'm not short maybe i'll give the high bend or raptor bend bars and see if i like them i do alot of jumping and just like the way to low bars feel

 

[raptormahi]

pro taper Raptor bend will work. :thumbsup:

 

[ATVhound]

These are the Trail Tech X bars mid bend. I am 6'2" and I like how these fit :thumbsup:

 

[Guest]

they look pretty good i geuss i need to get new bars

 

[mws]

You could probably use a set of 2" Rox Risers (or an extended steering shaft) with a CR Lo bend and avoid the problem.

 

[oli700]

Trail Tech clamp will raise you up 1 1/2"

 

[135boom]

here is what the protaper SE raptor bars look like. I went threw all this, tried all the SE's...and like what was said....it has nothing to do with the height...its the cross section that screws ya....and unfortunately all the standard SE's are the same. If you dont want them to rub, the raptor bend is the only way you can go...if you want protaper SE's.
Here are a couple pics of mine and the ladies. She has black...I have platinum

 

[YFZ-SLAYER]

ya gotta get the flexx bars, there nuts, awesome, google them