Raptor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Hi

i'm looking to change my handlebar and i'm lost on the manufacturer's bend table .

I want to keep my stock stem and use a 7/8 Ø bar.

I want a handlebar with a similar bend than the oem but with a lower position... 1/2 to 3/4 the oem height .

If you can show me some pic of your setup it would be apreciate...

Thank's
 

·
Registered
Joined
·
16 Posts
Discussion Starter #3
i have found the oem bend for each years of different bike on the renthal site...(fit my bike section).

A clamp area larger than 150-175(max) and the bar will probably hit the tank. Raptor OEM are 125...

So I ordered a Renthal 7/8 YFZ 450 04-05 bend !!!!
 
1 - 3 of 3 Posts
Top