Raptor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter · #1 ·
wheni go to start my bike it takes forever..does this have something to do with the main jets or the pilot and needle clips..i have dj jets at 146l 148r with 25 pilots the needles are dj also and the clips are the 4rth from the top...could this cause my hard starting prob its like its to rich when i try to start it...my a/f screws are 3 turns out on each side

thanks
 

·
Registered
Joined
·
441 Posts
Mine does the same thing. Sometimes it fires right up and other times it takes forever. I noticed when it takes forever its getting too much gas. Im sure I need a valve adjustment as well, that probably also plays a part in it.
 

·
Registered
Joined
·
9 Posts
I had the same problem; I readjusted the valve clearance to stock specs. This ceased the problem.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top