Raptor Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
I have the cover off, TDC is all lined up...but how do I get the sprocket bolt loose without moving the piston from TDC?
 

·
Registered
Joined
·
836 Posts
That is always a bitch to do!
I forget how my father did it when tearing down my last Raptor, but I have seen people keep the flywheel at a steady position with a giant torque wrench that is tight against the ground....
 

·
Registered
Joined
·
23 Posts
Discussion Starter #3
I used a bigger hammer! Once it was smacked a couple times it was loose. Now just need the new piston and gasket kit to get here!
 

·
Registered
Joined
·
836 Posts
what piston did you order?
 

·
Registered
Joined
·
23 Posts
Discussion Starter #5
vesely ordered a JD 12:1 for her raptor...should be here by Wed. Have to get it done so she can get some time on it before the race! :D
 
1 - 5 of 5 Posts
Top