Raptor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
I did some searching but never seen any posts with the same exact problem i have. I am running my dobeck at a 3 oclock setting. It is definately idling too high. The only way i can get the idle decsent is around 9 oclock. It seems like no one is running there idle setting that high so is it possible something else might be going on like a vacuum leak? I have also tried the idle screw with hardly no change. I am running a K&N, intake, no lid, and stock pipe with no sparky for now. Its pretty much been doing this since i put the dobeck on. Thanks for any help
 

·
Registered
Joined
·
1,832 Posts
:bump: for ya
 

·
Registered
Joined
·
29 Posts
Discussion Starter · #3 ·
thanks i was starting to think nobody read the post :( Oh well ill get it figured out one way or another :thumbsup:
 

·
Registered
Joined
·
29 Posts
Discussion Starter · #4 ·
Ok i guess i was a being a hairpie. I was trying to set the idle and the motor wasnt warm enough yet. Its responding good now.
 
1 - 4 of 4 Posts
Top