Raptor Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,463 Posts
dont waste your money go to the dealer and buy your jets, they are 2.50 each
 

·
Registered
Joined
·
1,674 Posts
Discussion Starter #3
Ok, well what exactly would I need to jet my Raptor? Just main jets right?

Here is what I need to jet for:

No airbox lid
Pro-Flo kit
Float bowl mod
Port matched intake tubes
Elevation: 750ft
 

·
Registered
Joined
·
22,016 Posts
pewterpecker said:
Ok, well what exactly would I need to jet my Raptor? Just main jets right?

Here is what I need to jet for:

No airbox lid
Pro-Flo kit
Float bowl mod
Port matched intake tubes
Elevation: 750ft
Main jets and pilot jets is what you will need.

Try this:

Mikuni 150 in the left carb
Mikuni 155 in the right carb
Mikuni 25 pilots
Mixture screw 2- 2.5 turns from fully seated.

If you ever buy an exhaust system, just bump your mains to a 155-160 main jet. If you do anything else motor wise, you might consider bumping your clip on the needle, but I wouldn't unless you invest in an exhaust system.

~Brian
 

·
Registered
Joined
·
176 Posts
what brian said...made a huge friggin difference in my quad. Im running that exact setup but bigger pilots.

Jetsrus.com has a good deal on jet kit (genuine mikuni) with stainless allen head screws for the bowls.
 

·
Registered
Joined
·
22,016 Posts
twistedwedge said:
what brian said...made a huge friggin difference in my quad. Im running that exact setup but bigger pilots.

Jetsrus.com has a good deal on jet kit (genuine mikuni) with stainless allen head screws for the bowls.
I'm running 27.5 pilot on mine, but the carbs are turned way down.

~Brian
 
1 - 6 of 6 Posts
Top