TTT
Kill switch wiring Q
Hey guys, I've got a Pro Design kill switch and I've got the ground wire done, but I have no idea what the intructions are talking about with the positive lead. Does anyone know where it goes?
1 - 7 of 7 Posts
What do they say?pewterpecker said:but I have no idea what the intructions are talking about with the positive lead.
Use the key wiring.
You can always go to the coil too.
You can always go to the coil too.
Do you know what color wire on the back of the key?
not sure i just piggybacked it to the coil
yes the cleanest way is to ground the ground to the back of coil behind frame and take the other lead and tie in with the front of the coil wire where it come off this is very clean been running 4yrs like this remember to clean end of kill switch every so often can rust on the inside! :thumbsup: NO CUTTING wires! :lol: here a pic to help
1 - 7 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Raptor Forum
A forum community dedicated to Yamaha Raptor owners and enthusiasts. Come join the discussion about performance, news, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
