Raptor Forum banner

Mix-N-Match Exhaust.

679 Views 4 Replies 5 Participants Last post by  phuzz
Can someone give me any reason why you couldn't use products from different manufacturers when putting an exhaust together?
If they offer a slip-on, it has to bolt up to the stock header.
Then it would seem that any aftermarket header offered seperately would have to mate up to any slip-on.

Am I wrong here?
Is there any reason not to do it, other than "that would be stupid?"
1 - 5 of 5 Posts
That’s the way I see it. You might need a gasket here and there but the length should be right.
but most of the time common sense doesnt prevail!!!!
Some manufacterer's headers don't match up with others slip ons.
I think so long as you are within the best amount/range of backpressure for the engine/mods, you should be fine.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top