Raptor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,674 Posts
Discussion Starter #1
I did the mods listed by freez (float bowl mods, match ported the intake tubes, lost the lid, K&N).... everything else is stock.

I was told that 150/155 with 25 pilots would work well... but I ordered Mikuni jets, were those sizes supposed to be for dynojet jets???
 

·
Registered
Joined
·
176 Posts
nah, you should be good with those jets bro :thumbsup:

thats the same Im running with the below mods..I just have 30 pilots with screws cranked down a little further.
 

·
Registered
Joined
·
1,674 Posts
Discussion Starter #3
Whew... thanks dude. I just wish it wasn't so cold so when I put them in I could run out and do some pulls to see how it runs... :'(
 
1 - 3 of 3 Posts
Top