Raptor Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,106 Posts
Discussion Starter · #1 ·
I programmed my PC before I installed it. This weekend I went to check everything while the the PC was installed. Everything seemed to be ok. My map came up and I was getting a RPM reading, however when I checked the accel pump numbers I got a no power commander message on my lap top. :3question:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top