Raptor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hey everyone,

Can someone who has rebuilt their raptor 350 help me identify this below washer?

I found it at the bottom of my engine case after opening it to replace a crank rod. I can't seem to figure out where it's suppose to go. I tried looking at the manual but no luck.

The second pic shows the general size of it. It's about the size of the dowel pin.

It's possible the previous owner dropped it down there because it looks like someone else has rebuilt it before.

Thanks for any help.
 

Attachments

·
Super Moderator
Joined
·
8,011 Posts
Interesting. Have you looked at an OEM schematic on any website? RMATV or the like?
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Hey morphrider,

Yeah I tried a similar site called yamahapartshouse but no luck. However their diagram drawings aren't exactly clear enough to distinguish between washers.

I think I'll probably just end up making sure i am not missing any engine/transmission washers and call it good.
 
1 - 3 of 3 Posts
Top