Raptor Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
665 Posts
Discussion Starter · #1 ·
just got this "pro armor race grab bar" and the directions call for plastic to be cut, anyone else have this bar and can mAYBE ELABORATE on the directions cuz thay are pretty vaugue, tahnks " PRO ARMOR RACE GRAB BAR"
 

·
Registered
Joined
·
54 Posts
Yeah I got one too. You have to trim the back left side plastics about 3/4 inch, tapered and about 3 inches wide I think. Just the part where they hang down in the back.
I mounted my grab bar first, then set the fenders on. Then I just started trimming with an air saw until the left fender rested flat. Turned out nice. Just an unexpected mod.

DJ
 

·
Registered
Joined
·
51 Posts
I have the pro armor standard grab bar. I assume the plastic trimming is about the same. I will post pictures of mine tommorrow.
 

·
Registered
Joined
·
54 Posts
I used an air saw to trim it. Pretty simple.

DJ
 

·
Registered
Joined
·
51 Posts
Here is a picture of mine. I cut the plastic with a razor blade while the grab bar was half-mounted.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top