Raptor Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi chaps, I have a raptor 660 and I am planning on putting a R6 engine in it, it will be my 1st build, so any and all advice would be great, will the engine fit without cutting the frame? I know I'll have to fabricate the mounts. Thanks in advance, Marc
 

·
Registered
Joined
·
290 Posts
It's not a direct fit and will take lots of time, money, and fabrication. Took me about 5 months to get my R1 Raptor rolling. You will need to cut atleast the bottom frame rails and make new ones.
 
1 - 2 of 2 Posts
Top