Raptor Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
First off I am not the owner of this so I dont know alot about it. But when you start it up it runs fine until it hits a certain part of the revolution in the motor and then bogs down and dies sometimes. Will run if you play with the throttle a little. I thought it just might be valves out of adjustment but I did them and no change.
He said he has already cleaned the carb up. I am thinking he may have a flat spot in the cam or something. Anyone have any ideas?
Thanks in advance
 

·
Master of the Electron
Joined
·
15,679 Posts
He didn't clean the carb completely - all jets and internal passages.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top