Raptor Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
Okay so i have the top end all taken apart. Im putting in a 9.9:1 piston, and a stage 1 hotcam. I want to DIY port and polish it. i know the basics but i would like a picture or two. Can anyone help please?!
 

·
Registered
Joined
·
36 Posts
Discussion Starter · #3 ·
ahh i dont have a phone. Like all i would do is match the ports with the intake, and, just smooth the exhaust out?
 

·
Registered
Joined
·
36 Posts
Discussion Starter · #6 ·
haha okay. Did you notice an increase in power?
 

·
Registered
Joined
·
881 Posts
A cam was also added the same time head got ported. But there was definitely a difference when it was put back together.










 

·
Registered
Joined
·
36 Posts
Discussion Starter · #8 ·
Thanks a bunch!
 

·
Registered
Joined
·
881 Posts
No problem i was also curious to know how to do a simple Port&Polish. I just read as much literature as i could find on the subject took notes and went from there takiing my time and not trying to rush anything. I barely removed any material from the middle valve floor.
 
1 - 9 of 9 Posts
Top