Raptor Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
Hey,

Just so you guys know I ordered a clymore because the yamaha dealer near me didn't have any manual's in stock, so I'm between a rock and a hard place because I need to tear out the axle this weekend and get it ready for powder coat on monday!! Any help is greatly appreciated!
 

·
Premium Member
Joined
·
956 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #4 ·
Hey, it I downloaded all of it and it helped me figure out how to remove the axle but I have no idea how to get the carrier out:/ and I née to get it and the seals and bearings out for powder coat,

Also there are some roller bearings where pivot bolt goes through the swingarm, I got the bushings out but I'm not 100% on how to get those roller bearings out any ideas?
 

·
Premium Member
Joined
·
956 Posts
Look at page 4-7 and that is how it comes apart.
 
1 - 5 of 5 Posts
Top