Raptor Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
138 Posts
Discussion Starter · #1 ·
How much effort is involved in changing out the throttle cable?
also
What kind of pleasant surprises should I be aware of when disassembling/reassembling?
I sure don't wanna see springs and screws falling and flying everywhere when I get the last screw out :eek:
and I would sure hate to spill out some ultra rare 'throttle cable housing fluid' that I wouldn't happen to have on hand :lol:
finally
Is there any final adjustments to make when reassembled? Is the original leverage ratio still intact?

thanks in advance
 

·
Registered
Joined
·
54 Posts
The throttle cable is fairly straight forward to do. It's been a while since I've changed mine out, can't think of anything that tried to put a halt in progress. Did you ruin yours or are you going to a twist throttle?

D.J.
 

·
Registered
Joined
·
138 Posts
Discussion Starter · #3 ·
It's not ruined, just tight with the risers I have on my bars.
I noticed that Motion Pro has extended cables, and I would like to change to those.

I'm asking about the effort involved because I want to know if I could go ahead and do it myself, or bring it in to a mechanic.

Is there a write-up on this somewhere?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top