Raptor Forum banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
4,191 Posts
Discussion Starter · #1 · (Edited)
Hey all, I've got a question, hopefully someone either has the answer right offhand, or at least can run out to the garage and take a quick measure for me. What is the stock length of the 660 tie rods? I ordered some +3's from ASR about a week and a half or so ago, and they just came in tonight. Opened the box and they seem REAL short to me. I measured them and they are just shy of 15 1/4 inches. I tried googling and I tried to find it on here too but I can't find a stock length. Thanks guys and girls!

For what it's worth, I'll be shaving about a 1/16th off of each end anyway of a +3, but I need to make sure I got the right length first, haha. Anyway, let me know!
 

·
Premium Member
Joined
·
4,191 Posts
Discussion Starter · #3 ·
Awesome, I appreciate it. I got a Diamond J from QuadManiac, and I'm not going to go +6, I only want to go +4.5, and that was one of his suggestions. That way if I decided to go +6 later, I would still have plenty of thread left.
 

·
Registered
Joined
·
6,002 Posts
1 foot 3/8" is the length. Sorry it took so long went out to the shop and my dog was fighting with a ****, and needless to say my ol Husky isn't the best fighter lol so I had to get out the gun and take care of it...
 

·
Registered
Joined
·
115 Posts
I didnt know president Obama was in Michigan today::mp5:
 

·
Premium Member
Joined
·
4,191 Posts
Discussion Starter · #7 · (Edited)
Hahahahahahahahahahahahahahahahahahahahahahahahaha! Classic! Thanks for taking the measurement too. I don't know why they look so short sitting here. Unfortunately I don't have my bike here to do a side by side comparison, otherwise I would have.
 
1 - 7 of 7 Posts
Top