Raptor Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
320 Posts
Discussion Starter · #1 ·
I ask this cause i made a attempt before on the trails with a socket set but the socket I used sliped so I called it quits cause I did`nt want to strip the bolt end. I need to know what size wrench/socket i need to lossen the 2 bolts up by the rotor not the adjusting bolts.
 

·
Super Moderator
Joined
·
17,061 Posts
17mm, the bike's metric so SAE tools are sloppy and more likely to round off the nuts.
 

·
Registered
Joined
·
320 Posts
Discussion Starter · #4 ·
thanks for info guys.... Incase I ring the bolt what the crap will i have to buy and do to get it out i know a little bit about tap outs. will i have to take anythang off if i round it off like tire/rotor?
 
1 - 4 of 4 Posts
Top