Raptor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
so im going to be putting my bike back together. originally when my quad wouldnt start i thought it was the carbs, so i was going to remove them and clean them, but i found the problem was in the electrical system. anyway, long story short, when i was taking off everything a hose came loose, and im not sure where it goes. one side of it is connected to the middle of the carb, but where does this hose run from there?
 

·
Registered
Joined
·
1,678 Posts
If I am thinking of the same hose, its mounted in the middle of the rear side of the carb, and it has two things on it where bolts screw into it, is this the same part?...

If so, two bolts from the carb protective top thing screw into it holding it onto the frame and holind the carb sleeve in place, and the other end of it does not connect to anything. I think its like a gas overfil line or maybe a gas vapor line. Hope that helps.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top