Raptor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
Ok so I've got a question, When I attempt to do the clear tube fuel level it constantly shows that I'm about 3-5mm above the shoulder. I have moved the floats to about 15mm and notched the stopper at about 45 degrees. Where is the middle ground when adjusting the floats and getting the 3mm fuel level below the shoulder? Right now when I start the monster it seems that its starving for gas, I think. I know I need to lower the fuel level but how with out losing the 14-16mm float?

Craig
 

·
Registered
Joined
·
1,637 Posts
Re: 3mm fuel level

You are supposed to be 3mm above the mating surface, not below.
 

·
Registered
Joined
·
56 Posts
Discussion Starter · #3 ·
Ok well if thats the case then my stuff is right on.

So it doesn't tell me why when I start it up I have to have almost full choke and it dies off when I start to take it down. Another thing is when I start it gas pours out of the carbs overflow, is this normal?

If even think of touching the throttle it kills. I have adjusted the valves, put in a new plug and new gas, adjusted the floats , and notched the floats.
Help.....
 
1 - 3 of 3 Posts
Top