Raptor Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter #1
Hey everyone, I know this has been a subject already talked about but I can’t find the answers I need. So I have the ROX offset 1 1/4 risers with the plate that holds the ignition. I purchased them for the pro taper contour raptor bend. I went to install today and no matter which way I set the riser(toward the back or toward the front), the push button start wire and the smaller wire on the clutch is not long enough. All the other cables and wires are except for them. I know I read a bunch about the clutch cables but I don’t know about the smaller wire coming from the clutch and really don’t know what to do about the push button start wiring. Please Help!
 
1 - 1 of 1 Posts
Top